变压器专业英语翻译,跪求各位英语达人翻译。

发布网友发布时间：2022-04-25 05:04

共5个回答

热心网友时间：2023-10-28 05:42

Roll the sealed type distribution transformer core is developed in recent years, the new generation of low noise, low loss, and its core transformer no juncture, rece no-load loss and no-load current no-load current, high ~ 80%, 60% lower in iron wire wound on continuous windings, tight, concentricity well. Noise dropped 10 decibels. Due to the continuous winding, iron makes full use of the manufacturing of sexual orientation, no-load loss reced by 20% ~ 30%, is a new generation of high-tech energy-saving and environmental protection procts.
The sealed type distribution transformer USES don't hang core structure, make internal and external tank completely isolated, no storage cabinets, the thermal changes in transformer tank operation by elastic corrugated chips to make compensation for expansion, transformer oil and insulation parts with outside air, water, and the separation of transformer oil and slow the aging in insulation parts. Seal of high fuel oil resistant balata, but not in the circumstance that hang core inspection operation for 20 years, rece operation maintenance cost, be helpful for the inconvenience. Some maintenance
The new type S9 oil-immersed three-phases transformer USES unified design standards, advanced and reasonable structure, insulation resistance short-circuit capacity is strong, its performance achieved the international similar proct level, with S7 procts, on average, no-load loss dropped by 10.25% no-load current decline 37.7%, load loss and lower average 22.4% appearance, reasonable structure according to user's chip and tank can tubular radiator, in recent years is one of the most widely used energy saving procts.
Developed SC9 series of epoxy resin casting dry-type power transformer and air insulated SG type dry type transformer insulation resistance short-circuit capacity, good performance, high impact resistance level of lightning. Epoxy resin casting dry-type distribution transformer winding high by epoxy resin casting seal, adoption of epoxy resin performance is good, crack, high temperature resistant, high mechanical strength, long service life. Flame retardant, moistureproof, explosion-proof pollution-free.
Procts, small volume, low noise. The winding in the operation of automatic temperature monitoring and are protected alarm device. In the forced air cooling can make the rated capacity over 40%. Can be widely used in high-rise buildings, station, wharf, subway, airport, power transmission and distribution system is the important place.
Combined-type distribution transformer (American box variable) is a new body, transformer switch, fuse, tap-changer and relevant auxiliary equipment in one of the transformer. With all its insulation, seal structure, and adopt double welding wire protection. Transformer core adopts special structure, low consumption, low noise, no heat, lightning case. High-pressure line adopts elbow joint, can operate cable 200A load current, can be done in an emergency operation, load switch with isolation switch features. Combined transformer, compact structure, small volume, cover an area of an area small, less investment, easy to install and can be widely used in airport, high-rise buildings, business center, dweller, streets, can further load center installation. When ordering, please indicate the combined transformer or terminal type ring network.
SZ type power transformer on-load changer, in use process for saving transformer on-load changer with reliable quality, reasonable, accord with national economic indicators GB1094-1996 power transformer and GB/T51-1999 "three-phase oil-immersed transformer, electric technical parameters and requirements. Core adopts the high quality manufacturing, advanced proction technology, Oil and winding road structural design is reasonable, high mechanical strength and resistance short-circuit capacity is strong, beautiful generous.

仅作参考

热心网友时间：2023-10-28 05:43

做人要厚道，你这哪是让人帮忙，简直就是找无偿劳动力啊。翻译是需要时间的，对不起，咱没那么多时间翻译，但给你提醒一点，切勿把人家给你翻译的拿去直接用了，还是找个搞电气类专业英语好的人给你翻译吧，别整出笑话来了。

热心网友时间：2023-10-28 05:44

热心网友时间：2023-10-28 05:45

参考资料：我自己查的，学者死

热心网友时间：2023-10-28 05:45

Volume sealed type transformer core is developed in recent years a new generation of low noise, low-loss transformer, the core of seamless, large rection of the load loss and no-load current, so that no load current by 60% to 80%, high and low voltage winding around the pillar on the continuous system, winding tight, concentric. 10 dB above the noise down. As the core continuous winding, full use of the orientation of silicon steel, making the no-load loss reced by 20% to 30%, which is a new generation of high-tech energy-saving environmentally friendly procts.
Sealed-type distribution transformers with non-suspended core structure, so internal and external fuel tank completely isolated, no storage cabinet, the transformer in the operation of thermal expansion changes in the elastic wave from the tank to do film shrinkage compensation, transformer oil and insulation conditions and outside air, water separation, transformer oil and thus slow down the aging rate of insulation parts. Seal oil tank with high-performance rubber, can be suspended in the field do not guarantee the core inspection run for 20 years, recing operating maintenance costs and will help maintain the inconvenience of the place.
The new S9 Three-phase oil-immersed transformers with a unified design standard, advanced and reasonable insulation, short circuit capability, its performance has reached the international level, compared with the S7-type procts, down 10.25% on average no-load loss, load current decrease of 37.7%, 22.4% lower load loss average, reasonable structure, beautiful appearance and may be based on user requirements and the fuel tank can be a piece tube heat is the most widely used in recent years, energy-saving procts.
SC9 epoxy cast dry-type distribution line transformers and air-insulated dry-type transformers SG, good insulation, anti-short circuit ability, resistance to high levels of lightning impulse. Epoxy cast dry-type distribution transformer high-voltage coil sealed by epoxy resin casting, using epoxy resin performance, cracking, high temperature, high mechanical strength, long life. Flame retardant, moisture-proof, explosion-proof non-polluting.
Proct size, low noise. The windings are in the operation of automatic temperature monitoring and protection alarm. When forced air cooling can over 40% of rated capacity. Can be widely used in high-rise buildings, stations, airports, docks, subways, power plants and other important areas of transmission and distribution systems.
Molar power distribution transformer (American box changes) is a set of Transformer body, switch, fuse, and the corresponding tap auxiliary equipment in one of the transformers. It uses fully insulated, sealed structure, and double fuse protection. Transformer core with special structure, low loss, low noise, no heat box, mine good performance. High-voltage cable into line with the elbow joint, operational 200A load current, can do in an emergency load switching with isolation switch characteristics. Combined transformers, compact structure, small size, small footprint, low investment, easy to install, can be used in airports, high-rise buildings, commercial centers, residential areas, streets and other places, in-depth load center installed. Please specify when ordering combined transformer terminal type or ring type.
SZ-type power transformer load tap, in the course of on-load tap-saving and reliable quality, reasonable economic indicators, in line with national GB1094-1996 "Transformers" and GB/T51-1999 "three-phase oil-immersed power transformer and technical requirements. " High quality silicon steel core, advanced proction technology; Winding Road structure, reasonable design and oil, high mechanical strength and resistance to short-circuit capability, looks nice.

全部栏目

变压器专业英语翻译,跪求各位英语达人翻译。