发布网友 发布时间:2022-04-26 07:40
共1个回答
热心网友 时间:2022-06-25 09:56
天迁移以前的一个装有flexlm的虚拟机,结果发现在迁移后启动时报错
... Wrong hostid on SERVER line for license file
...
... SERVER line says 00e081787ba8, hostid is (Cannot get hostid of type 2 [])
... Invalid hostid on SERVER line1234
解决办法
从问题描述看,好像是取到hostid有问题,用lmhostid检查一下,发现取到的hostid为”“
./lmhostid
lmhostid - Copyright (c) 19-2004 by Macrovision Corporation. All rights reserved.
The FLEXlm host ID of this machine is ""123
由于FLEXlm会使用第一块网卡(eth0)的mac地址做hostid,所以用ifconfig检查网络配置,发现其中没有eth0,如下:
eth1 Link encap:Ethernet HWaddr 00:E0:81:78:7B:A8
inet addr:192.168.0.88 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::2e0:81ff:fe78:7ba8/ Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2463804 errors:0 dropped:0 overruns:0 frame:0
TX packets:345560 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:924819172 (881.9 MiB) TX bytes:34087357 (32.5 MiB)
Interrupt:11
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:2843863 errors:0 dropped:0 overruns:0 frame:0
TX packets:2843863 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:729294023 (695.5 MiB) TX bytes:729294023 (695.5 MiB)1234567101112131415161718
但是在用linux自带网络配置工具和/etc/sysconfig/network-scripts/下的文件配置看,确实是用的eth0。这说明配置出现了不一致问题。
最后,检查/etc/udev/rules.d/70-persistent-net.rules文件
# PCI device 0x1af4:0x1000 (virtio-pci)
SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*l", ATTR{address}=="00:e0:81:78:7b:a8", ATTR{type}=="1", KERNEL=="eth*", NAME="eth0"
# PCI device 0x10ec:0x8139 (8139cp)
SUBSYSTEM=="net", ACTION=="add", DRIVERS=="?*", ATTR{address}=="00:e0:81:78:7b:a8", ATTR{type}=="1", KERNEL=="eth*", NAME="eth1"12345
发现了问题,里面有两个网卡配置项,果断修改为